Capstone Mfg

BEFORE OPENING COOLCAR CERAMIC READ ALL APPLICATION INSTRUCTIONS:

CAUTION: DO NOT DILUTE PRODUCT IF SPRAYING.

 

PRODUCT CAN BE DILUTED WITH 1 TO 2 OUNCES OF WATER PER GALLON ONLY IF USING BRUSH ON APPLICATION, BUT NOT RECOMMENDED                       

 

TOOLS REQUIRED FOR BRUSH ON APPLICATION:

**A 2" OR-3" Foam or bristle brush

 

TOOLS REQUIRED FOR SPRAY ON APPLICATION:

**AR-1 gun.  (AR-1 compressed air spray gun is recommended.  It has higher volume capacity.)  (See products page)

**A 6 feet to 8 feet or 1.8 to 2.4 meters of thick walled rubber hose, approx. ½ in. or 1.0 cm siphon tube

**A mud paddle

**A 5 amp variable speed drill (300 RPM or less)

**2 hose clamps to fit suction hose

Before trying to use other types of spraying equipment, check with your dealer

 

SURFACE PREPARATION:

CoolCar Ceramic will adhere to nearly all types of surfaces: metals, wood, plastic, glass, plexiglas, etc. Surfaces should be prepared similar to that required for proper adhesion of normal paint: clean, free of dirt, rust, grease or other foreign matter such as scales, paint chips, etc. Surfaces must be dry during the application. Hot metal surfaces may require a more thorough preparation, such as wire brushing, to ensure best adhesion. New metal surfaces may require removal of temporary preservative coatings. A light combination of vinegar and water works well.

 

DO NOT ALLOW PRODUCT TO FREEZE

Keep product in cool storage place.  Product is not usable once frozen.

 

 

APPLICATION INSTRUCTIONS:

Do not open product until ready to apply.

It is recommended to use all of the product in one single application. It is not recommended to reseal pail for future use of any remaining product, unless it will be used within a few weeks.

Insert the mud paddle into drill, push the mud paddle up and down through the product to break up crust. Start the drill slowly, DO NOT RUN DRILL ON HIGH SPEED. (Do not exceed 300 rpm.) Mix until product is creamy

Take lid off pail, attach a hose to the handle of the pail when using AR-1 spray gun with hose. This will prevent the hose from pulling out of pail. Attach hose to spray gun with hose clamp. You are now ready to spray. Shop air of 60 to 80 psi is recommended. Surface must be clean.

Product should be applied in coats of 15 to 20 mils/0.3 to 0.5mm per coat. Let product cure between coats (24 hours recommended).  Recommended 40 mils thickness to the inside of street rods and 60mils or greater for race cars or for the inside of wheel wells.

Coverage is 20 sq. ft./2 sq. meter per gal./3.785 liters at 40 mils/1.0mm thickness

Total curing time per coat is 12 hrs. at 70F/20C or more with high air flow.

 

 

DO NOT ALLOW PRODUCT TO FREEZE

Keep product in cool storage place